2014-2018 GM Truck

This kit has been developed to seamlessly retrofit the 10 speed transmission into the 2014-2018 Silverado / Sierra.


Kit includes a plug and play harness, pre-programmed and unlocked transmission control module, and our PSS Conversion Module. No further re-programming is necessary for installation, but may be needed for optimal performance.   


The following models are supported with this kit:
2014 - 18 Silverado / Sierra equipped with factory six and eight speed transmission, two or four wheel drive.


Retains ALL OEM vehicle features including, but not limited to:

Remote Start
Cruise Control
Immobilizer
Antilock Brakes
Traction Control
Forward Collision Alert
Backup Camera
Torque Management
Manual Mode
Tow/Haul Mode
Manual Mode Gear Position Indicator 1-6 or 1-8 (Maximum for OEM Equipped Display)

Our harnesses are proudly handmade in the USA with the highest quality components to ensure years of worry-free service.

*INSTALL NOTES*

2WD 
-OEM ride height vehicles can retain the same driveshaft.
-OEM 8L90e vehicles will need to change to a 6L80e slip yoke.
-Lowered vehicles may need the driveshaft shortened.
-Custom driveshafts available upon request.

4WD
Transfer Case: -OEM six and eight speed transfer case can be re-used by shortening or replacing the input shaft.

-2018-2020 ten speed transfer case is also a direct replacement for electric shift vehicles, but will need a relearn after install.

Some additional small parts required. These variations will be covered in our Q&A section, but at this time - Supplemental parts list for the small parts required to complete install will be provided with the install kits, and instructions.

More info to come as time allows -